Satisfactory Wiki
Register
Advertisement
This article is a stub. You can help Satisfactory Wiki by expanding it.
This article may need cleanup to meet quality standards.
Please help improve this if you can. The Discussion page may contain suggestions.
Reason: "Article is poorly written"
Smart Splitter
Smart Splitter
Splits conveyor belts in three.
You can set a rule for which part should go to the left and which part should go to the right.
Building
Category Logistics
Subcategory Sorting
Unlocks at Caterium Research
Inputs 1
Outputs 3
Dimensions (Area 25 m2)
Width 5 m
Length 5 m
Height 4m(+1m into the foundation) m
Required items
Reinforced Iron Plate
2
Rotor
2
A.I. Limiter
1

The Smart Splitter is a smart version of the Splitter that allows for setting one filter on each of its outputs. It is useful when you have a conveyor belt that transports different items and you want to split one type of item out and onto another belt.

Mode of Operation

  • Looking into the input of the splitter, the splitter has 3 outputs named Left output, Center output, and Right output.
  • Each output can be set to one filter for a specific item (which you can choose from a list), None, or Any (indicated in the splitter as an asterisk *).
  • Note that "Any" in this respect means anything not filtered on the other outputs.
  • The outputs are processed in a specific order: center output first, left output, right output. If all output matching a specific item type is full, the input is blocked and no further items will be passing through the Smart Splitter until the output is cleared.
  • If no belt is connected to an output, make sure to set its filter to None or the input will block if that item passes through the Smart Splitter.
  • You will probably also want one output to be Any, and have a belt connected to that output. You can omit this if you will never put anything on the belt other than the items filtered.

Usage cases

The most typical usage case is to use Smart splitters to distribute an incoming belt or truck station from a faraway production outpost into belts for individual items.

Trivia

  • When using a Smart Splitter to separate items out for use as input into a production building, you will want to add buffers in the form of Storage Containers on the outputs of the Smart Splitter. Without this, it is going to be very easy to block the input of your Smart Splitter and make it somewhat difficult to resolve issues manually.
  • It is impossible to perfectly balance inputs and outputs of production buildings, so using Smart Splitter outputs anywhere as production inputs will at some point in time require manual intervention to clear a blockage. Adding more/bigger output buffering reduces the incidence rate, but keep in mind you may need to intervene at some point in time.
    • The AWESOME Sink can be used to dump excess items to prevent blockages at the cost of 30 MW of power, however some items will be lost to the Sink even when the system is not blocked.
  • You can perfectly replicate the functionality of the Programmable Splitter using a chain of Smart Splitters and Conveyer Mergers on the outputs. The main advantage of the Programmable Splitter is that it is easier to build and configure, and uses much less space. But if you don't yet have access to the Programmable Splitter, this can be done.

History

Gallery

See also


Advertisement